Lets get your new Lowrance Eagle Fish Finder visor installed. Follow this simple guide to get it right first time!
Step 1:
Gather the Components: Before you begin the installation, ensure you have all the necessary components readily available. You’ll need the Lowrance Eagle unit, BerleyPro Visor, M3 x 10 Phillips pan head screws, flat washers, nylock nuts, Stainless Steel tabs, a screwdriver compatible with Phillips screws, and the user manual. Verify that all the components are in good condition, and ready for a smooth installation process.
Step 2:
Remove the Corner Tabs: Refer to the user manual for instructions on removing the corner tabs from your Lowrance Hook/Reveal unit. Follow the manual’s guidelines carefully to detach the tabs without causing any damage to the device.
Step 3:
Attaching the Screws, Washers, and Nylock Nuts: Using the appropriate screwdriver, take the M3 x 10 Phillips pan head screws and insert them one by one through the designated holes on the unit. Place a flat washer onto each screw at the top of the unit.
Step 4:
Use the Stainless Steel tabs for the bottom corners. On the backside of the mounting surface, secure each screw with a nylock nut, ensuring a tight fit. Tighten the screws and nylock nuts securely, but avoid over-tightening. Re-install the corner tabs as per the instructions in your Lowrance user manual, you are set to now install your unit onto your boat or kayak.
Need one? Shop the Lowrance Fish Finder Sun Visors.