If you’re a kayak angler looking to improve your fishing outings while safeguarding your investment in a Bonafide P127 Kayak, the BerleyPro Bumper Bro provides a dependable solution. In this guide, we’ll present you with a detailed walkthrough for installing the Bumper Bro using double-sided tape. By following these instructions, you can achieve a sturdy and long-lasting attachment without resorting to screws. Let’s delve into the instructions and get your Bonafide P127 Kayak outfitted with a BerleyPro Bumper Bro promptly!
Step 1: Find the Optimal Placement and Adjust the Bumper (if needed): Find the Optimal Placement and Adjust the Bumper (if needed): Position the BerleyPro Bumper Bro on the kayak’s bow or stern in a way that minimizes any gaps. Use masking tape or a pencil to mark the chosen location. If required, reshape the bumper using a heat gun to ensure proper alignment with the kayak’s contours.
Step 2: Clean and Prepare the Surface: Clean and Prepare the Surface: Thoroughly clean the mounting surface on your Bonafide P127 Kayak using isopropyl alcohol to remove any dirt, grime, or residue. Ensure the surface is clean and dry for optimal adhesion.
Step 3: Clean the Bumper Bro: Clean the Bumper Bro: Clean the inside surface of the Bumper Bro with isopropyl alcohol, allowing it to dry completely. This will ensure a clean and suitable surface for bonding.
Step 4: Install the Bumper Bro: Apply Double-Sided Tape and Secure the Bumper Bro: Check the fit and orientation of the Bumper Bro on your Bonafide P127 Kayak. Apply double-sided tape along the sides of the bumper and the centerline of the kayak’s keel. Position the bumper on the kayak, aligning it with the hull’s contours. Firmly press the bumper against the kayak’s surface, ensuring a secure attachment. Apply additional pressure to ensure the tape adheres properly.
By following these four steps, you can successfully install the BerleyPro Bumper Bro on your Bonafide P127 Kayak using double-sided tape. This will provide a sturdy and long-lasting attachment, allowing you to improve your fishing experiences while protecting your kayak investment.
I have a hobie compass (hull is made of polyethylene ) Bought a berleypro bow keel guard recently. Is double sided tape good enough to hold keel guard? Should a marine glue be used? Which one? What’s cost effective solution? Thanks
Hi, we always recommend to use marine goop over double sided tape thanks
I used Gorilla Glue waterproof double tape on this. I have put it to the test and it is holding with no issue. Tho I will agree with Martyn. Marine Goop would be the better solution. This is what I had and used it.
Will this fit the Bonafide 107 as well? Thanks.